Characteristics:

1. Support Windows XP, WIN7, WIN8, WIN10, support Tablet PCs, support 64-bit systems

2. peripheral wide voltage input, with anti-reverse function.

3. All input signals are isolated by optical coupling and can be connected to emergency stop, knife, limit, return to zero, etc., to protect the safety of the computer.

4. 4 output ports can be connected to relay module with optocoupler to control water cooling and spraying.

5. At the same time, provide 5-axis interface line socket (HX2.54), convenient to control the stepper motor driver.

Specifications:

1, Fully support MACH3 software.

2, support Windows XP, WIN7, WIN8, WIN10, support tablet PCs, support 64-bit systems.

3, peripheral wide voltage input, 12-24V and anti-reverse function.

4, All input signals are isolated by optocoupler, which can be connected to emergency stop, knife, limit, return to zero, etc., to protect the safety of the computer.

5, Provide 0-10V analog voltage output isolated by optocoupler, which can control the inverter with 0-10V analog voltage input to control the spindle speed.

6, provide opto-coupler isolated PWM output (5V level) to control other PWM controlled spindle speed controller.

7, Provide 4 output ports (5V level), which can be connected with relay module with optocoupler to control water cooling and spraying.

8, can be connected to the common positive or common negative input, level of 5V, with optocoupler input stepper motor driver.

9, at the same time provide 5-axis interface line socket (HX2.54), convenient to connect the stepper motor driver.

The inverter must be set in general:

1, Set the frequency converter to remote terminal start.

2, set the frequency control mode of the inverter to analog (0-10V) input control.

Fast test converter is not yet set up:

1, the inverter is not connected to the interface board first.

2, the inverter FWD and COM short, the inverter 10V and VI short. Connect the spindle. (Of course, according to the figure with a potentiometer to the inverter)

(Of course, according to the figure with a potentiometer on the 10V of the inverter, VI and GND is better).

3, power on, if the inverter can run at maximum speed, the spindle rotation is normal, basically means the settings are correct. (If you use a potentiometer, the speed is adjustable).

4, so that you can according to the above method and interface board wiring!

Remark:

General inverter has a variety of control methods, so it is generally necessary to set it. Light wiring without setting is basically impossible, so check the inverter manual and setting is a necessary step!